Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ adjust closer speed ”

RELATED FAQS

Resolution: How to: What are the steps to adjust a door closer? Facts: All LCN and FALCON door closers will have 3 regulating valves and a spring adjustment. All closers with a "Del...:

How do you slow down the closing speed of the 4600 series operator?

Resolution: The hydraulic closer underneath the control box has 3 regulating valves (like any 4040 series hydraulic closer). Main Speed - adjust closing speed from 90° open down to 10°. Latch Speed - adju...:

Is there adjustment limits on the regulation valves of LCN manual closers?

Resolution: The regulation valves are designed to adjust the flow the hydraulic fluid in the closer which regulates the door closing speed through various phases of the closing cycle. The regulation valv...:

How do I set the hold open on my 4040 closer?

Resolution: The hold open position on a "REG" or "EDA" hold open arm is set with the door to a few degrees shy of the desired hold open point. To properly set, open the door 5° less then the desired hold open...:

How to adjust a 4010 hold open arm?

Resolution: The correct method (process) for setting the hold open is: The 4010 hold open arms are handed, verify correct hand arm. (R or L stamped on main arm) Loosen the hold open nut. Opened the door ...:

What size Allen wrench is used for Closer adjustment?

Resolution: LCN does not supply Allen wrenches. The size allen wrenches that LCN uses, are standard sizes that every installer will have in their tool kit. 3/32" Allen wrench for adjusting&...:

What would cause a door closer to slam?

Resolution: There are a few things that can cause a closer to slam. The closer could be adjusted incorrectly. Turn all regulating screws clockwise until they stop. Then open each valve 1 and 1/2 turns. If t...:

When did they start putting the green dial's on the 4041 closers?

Resolution: LCN started putting on the green dials for the spring adjustment on the 4041's in 2001.: