Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
AD series tailpieces
”
RELATED FAQS
Question
Answer
What is the part number for the twisted tailpiece for AD/CO exit device trim locks?
Resolution:
The part number for the AD or CO twisted tailpiece kit is: 46929303 Tailpiece Kit - (for Exterior Escutcheon -993 into Exit Device, i.e. Von Duprin 98 or 99) Exit Trim 46929303 Includes the...:
Which tailpiece do I use for the AD993-R or the AD993-M?
Resolution:
In the AD and CO Series replacement parts guide it shows the same part number 46929295 for the 993R, 993S, and 993M. The pictures show that the 993R and 993S have a flat straight tailpiece and the ...:
Why can't I get my JD YA6 cylinder to install into an AD-Series lock?
Resolution:
The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder. Interchangeable cylinders assume that the lever and taipiece is i...:
Reinstalling an AD-993 Tailpiece Holder Assembly
Resolution:
Below is the link to the document that shows how to install the AD993 tail piece assembly: Reinstalling an AD-993 Tailpiece Holder Assembly:
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
Will Falcon B locks prepped for BD accept a 6 or 7 pin core?
Resolution:
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for bo...:
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...: