Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ AD-Series Lock Re-Classing Guide ”

Resolution: Re-classing is the process by which an AD-Series device is able to change its lock type. The AD-Series has a modular architecture and a major benefit of this type of architecture is that it allows ...:

What process should be followed to change the Credential Reader type on a AD-Series lock?

Resolution: The process to change the Credential Reader on an AD-Series lock is as follows: Note: To ensure firmware compatibility of the lock and reader, it is important that the firmware in the LOCK and the...:

Can the AD-Series and CO-Series magnetic card credential readers be set to read data from different magnetic card tracks?

Resolution: Customers will need to use the Schlage Utility Software (SUS) on the HHD lock programming device to set the desired magnetic track to be read for access control, if not using default Track 2&n...:

What causes the error "Device does not support this action - E802" when I'm coupling an AD lock?

Resolution: In order to properly couple, the interior pushbutton must be held down while tapping the SW1 (tamper switch) three times. This will enable the lock to couple to the HHD.:

AD changing Function in the field

Resolution: -On the AD series offline locks only you can change the lock function from Classroom/Storeroom to a Privacy, office or apartment function out in the field. - This is done via the HHD/SUS using...:

What current should an AD-Series or CO-Series lockset draw while in its low power "Sleep" mode?

Resolution: Use a multi-meter in series with the batteries to measure battery current. Be sure your multi-meter can accurately measure very low current, in the micro-amp range. See the attached Technical Not...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ AD-Series Lock Re-Classing Guide ”

RELATED FAQS