Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Can you run 24volts thru the NO and C of the 900-FA board?

Resolution: Yes, 24VDC is fine, since the relay on the FA board is rated for 30VDC 1A max.:

Is the tailpiece for the CO and AD cylinders different from the NDE lock cylinders?

Resolution: The AD and CO locks do NOT have the same tailpieces as the NDE locks. They are different lengths. :

Where can you punch the ISO cards

Resolution: Please see attached.:

What terminals in back of HKII reader is need to be shorted to stop the message, "Door open too long"?

Resolution: Pins 10 and 11:

What does LGR indicate for PS902 2RS LGR?

Resolution: LGR refers to the finish of the power supply, light grey.:

What is the dimensions of the CT5000 USB wall plate?

Resolution: The dimensions are 4 1/2 X 2 3/4 X 5/16 inches.:

Are the IBF credentials waterproof?

Resolution: The iButton chips are IP56 rated. The button is basically rated for protection against short periods of immersion in water.:

What is a direct replacement for the 6010 del exit device?

Resolution: There is no direct replacement. The 6010 DEL was a smart exit crash bar with CM lock on exterior and delayed egress module in the crash bar.:

Can a flood barrier shield be left in place permanently?

Resolution: As a general rule, the barrier should not be left in place permanently. The gasketing can be impacted by environmental conditions such as temperature and sunlight, especially for exterior con...:

Does the vinyl cover of the CS115 crash stop match the finish ordered?

Resolution: The CS115 Crash Stop will always have a gray vinyl covering regardless of the finish ordered.: