Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Would the 660-T4 or 660-PB mini station work with any elecrified panic exit device?

Resolution: The 660-T4 or 660-PB is just a dry contact momentary or toggle switch. As long as the voltage and current that is being passed through the switch does not exceed the switch rating, it should be a v...:

Can weep holes be ordered for my exit device?

Resolution: As of 10/8/2013, the weep hole option is available through standard order entry process. This is available for rated doors as well.:

Lock address settings for legacy Schlage / Locknetics PIBs

Resolution: Lock Address Settings Dipswitch 1 LOCK 2LOCKS 3LOCKS 4LOCKS 11 OFF ON OFF ON 12 OFF OFF ON ON 13 MUST BE SET TO OFF ...:

How to address a Schlage / Locknetics VIP legacy lock

Resolution: Lock Dip switch settings: DIP SWITCH SETTINGS 1 2 3 4 OFF OFF OFF OFF Lock Address: 01 (RSI, INTERFLEX, VIP) ON OFF OFF OFF Lock Add...:

are the keypads waterproof KP212 KP2000 KP232

Resolution: The Current KP line of keypads KP212 KP2000 KP232are NOT water proof but are moisture resistant. Protection against excessive exposure to water is recommended. :

Will the SNAP reader enroll iButtons on Windows 7?

Resolution: The way Windows 7 supports USB controlled devices is totally different than how Windows XP supports USB controlled devices, such as the SNAP programmer that was designed specifically for the Window...:

Does Schlage offer ND conversion kits to convert to Classroom Security function?

Resolution: For all available ND Series Conversion Kit part numbers, click here.:

What is the part number for companion or slave M490DE maglock module?

Resolution: The part number for the companion or slave M490DE maglock module is: P44488443 for Basic M490DE model. P44488468 for M490DE Plus model. :

The MTMS15 or MTMSK15 reader does not read a magstripe card

Resolution: The three most common reasons for these are as follows: 1. During installation, the wiring for the magstripe reader may not have been connected to the main reader. Please remove the ma...:

How to program A Network Reader with Keypad

Resolution: Step 1 Power Cycle Reader Step 2 Within 1 minute from power cycling unit perform following tasks; 1. Enter *88889999 on the keypad or if not keypad, 2. Present configuration card CX-0...: