Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

Resolution: Due to the design of the 280+ control module the 280+ when bonding, will be louder then a the typical direct pull mag lock. This can be more pronounced by door and frame material. The boding of the...:

320M maglock Amperage

Resolution: The 320M(Mortise) amperage is higher at 24VDC( .45A ) than at 12VDC( .23A )The unit uses one coil as opposed to two coils as in the all other mag locks. Thus as voltage increases thr...:

390 DEL System 7 Programming swich positioning.

Resolution: When using system seven programming, ensure proper switch positioning. Locate the SW4 dip switch bank, Set the Number 1 position to off when programming ibuttons. If SW4, po...:

How to Identify a Programmable Lock

Resolution: Visual identification of programmable locks.: How many buttons does the lock have? Ø 6 Buttons o Are the buttons surrounded by metal or black plastic? § Metal – Cobra §...:

Is the E-Series HandKey handed?

Resolution: Yes, the E-Series HandKey is handed: Interior applications: ID3D-R is a right handed E-Series HandKey LH-100 is a left handed E-Series HandKey Exterior applications: ID3...:

How do I flash the firmware on a AD / CO product Line

Resolution: Firmware upgrade procedures are detailed in the Schlage Utility Software ( SUS ) user guide.See Appendix B: Device Firmware Update AD-Series and CO-Series Device Firmware Update .:

What replaces the Von Duprin PS873 power supply?

Resolution: Option Board Von Duprin PS914 Schlage PS902, PS904, PS906 900-2RS Yes No 900-2Q ...:

When were 313AN & 315AN anodized finishes changed to SP313 (695) and 622 powder coat finishes?

Resolution: Beginning December 6, 2010, all 33A, 35A, 98 & 99 devices ordered as 313AN Anodized was furnished in SP313 (dark brown powder coat). All devices ordered as 315AN ...:

Cam screw loosening and falling off on modular cylinders.

Resolution: Locked down to tech There have been a few reported cases of the torx cam screw loosening on modular designs shipped prior to April 16th 2013. History of c...:

Can I convert an L9000 electrified lock to fail safe or fail secure?

Resolution: Procedure for the L9080EL/EU and L9082EL/EUTo modify an electrified L9000 from EU to EL or EL to EU move the link pin to the appropriate location indicated below in Figure 1. :