Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the part number for the 6210 spring and lip replacement package?

Resolution: You can replace the 6210 spring and lip, part number 050940-00.:

What is the minimum stile for the 98/99 rim device?

Resolution: Minimum stile depends on several factors. The information will be on the specific template for your door and hardware.Start by opening the templates page.Click here -->: 98/99 T...:

Which electric strike would I use with an HL6?

Resolution: You could use the HL6 Hospital Latch with any electric strike that would work with a cylinderical latch such as the 5100, 6211, etc.:

What makes the ALK sound?

Resolution: Once the exit alarm (ALK) is turned on & armed, activating the push bar provides a "short" across the TB1 from the RX or LX switch will cause the piezo horn to sound.:

Can Falcon 712L trim be used with 25R exit device?

Resolution: The 510L trim needs to be used for the 25-R as the trim needs to lift up on the lift bracket on the 25-R device center case to operate device's latchbolt.:

Can the Ives 112HD hinge be cut to size?

Resolution: The Ives 112HD hinge can be cut to size, the cutoff direction are on the installation instructions.:

Does the SL-Series door have a square edge?

Resolution: The SL-Series door is a square edge non-handed door. A Hinge Filler (also referred to as Hinge Spacer) is the small removable trim part located on the door between hinge leaf and hinge reinforcem...:

What is the part number for the Schlage cylinder to work in a Falcon T lock?

Resolution: The Falcon T series was discontinued August 12th, 2026 and was replaced by the Falcon TM series. Schlage offers Falcon Retrofit cylinders to fit many of Falcon's locks. Table 1 below con...:

What type of cylinder is the 30-001?

Resolution: The 30-001 is a conventional mortise cylinder with a clover cam, compression ring and spring for use on rose trim. For use with the L9000 mortise locks except for the L9060 outside cylinder.:

Does Von Duprin still sell mag locks?

Resolution: Von Duprin discontinued selling mag locks in the early 1990's.: