Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is a Door Position Switch (DPS) for a Chexit device?

Resolution: A Door Position Switch is a switch and magnet mounted on the door and frame that monitors the door status. If door is held open beyond rearm time or if door is forced open, alarm wil...:

What special template (ST) is used with the 4041EDA and a GJ 814-816?

Resolution: You will need a 4040XP closer with an EDAG arm and use Special Template ST-3448. :

Is the 33-006 cylinder plug available?

Resolution: The 33-006 plug is no longer available.:

What is the part number for the dogging assembly on a 22, 33A/35A, or 98/99 series devices?

Resolution: There is no single part number for a dogging assembly (since August 1998). If you look at the baseplate assembly in the parts manual you will find the dogging shaft, dogging hook, dogging spr...:

Is there a back box for Chexit so they can put the CX module in a remote location?

Resolution: If you need to cut a CX device down it is possible to relocate the CX PCB to an external enclosure. This is done by ordering the CX device as an RCM or Remote Chexit Module. See ...:

Why is my E996L solenoid getting hot?

Resolution: This is usually an indicator of applying excessive voltage. Measure the voltage going into the solenoid and make sure you have 24-26.4VDC cross the two wires going into the solenoid. Also measure ...:

What does XQ06-878 stand for?

Resolution: The XQ06-878 is used to stamp "DO NOT DUPLICATE" on a key.:

How long should programming new door files into an AD-Series or Co-Series offline locks take?

Resolution: To improve door programming file speed, upgrade your SUS to version 4.1.0 or higher:

Resetting the AD400 Lock to factory default settings

Resolution: Level 1 (FDR) Factory Default reset1. Remove the top inside cover. 2. Press and hold Schlage button on the reader wait for (2) beeps and (2) green flashes (appx 10 seconds). 3. Release the Schlag...:

Is the wiring harness found in both the KR 4854 and standard 4854 mullions?

Resolution: The male and female receptacle wire assemblies (wiring hardness) are included in 48/9854 and KR48/9854 mullions. The wiring harness is the same in a 4854 and 9854 mullions. 105987 is the part n...: