Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

How do you reset a biometric F-Series handreader with dip switch settings?

Caution: Resetting/cold booting a biometric handreader resets the handreader to factory default settings and erases the user database.

To reset or cold boot a biometric F-Series handreader with dip switch settings:

  • With system power OFF, set both switches 4 and 5 ON.
  • Turn system power ON and wait until "Ready" is displayed on a HandKey or until "Enter ID" is displayed on a HandPunch.
  • Turn both switches 4 and 5 OFF.

NOTE: Before putting the handreader into service, check that dip switches 4 and 5 are both set to OFF. If dip switches 4 and 5 are not set to OFF, the next time the handreader's power is cycled, i.e. unplugged and plugged back in, the handreader’s memory will be erased.

To warm boot a biometric F-Series handreader with dip switch settings and retain the user database:
  • With the system power OFF, set switch 5 OFF.
  • With system power OFF, set switch 4 ON.
  • Turn system power ON and wait until "Ready" is displayed on a HandKey or until "Enter ID" is displayed on a HandPunch.
  • Turn switch 4 OFF.


DISCLAIMER:

INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS REPRESENTATIONS OR WARRANTIES OF ANY KIND, AND WE MAKE NO REPRESENTATION OR WARRANTY THAT THIS SITE(OR ANY INFORMATION PROVIDED IN RESPONSE TO YOUR INQUIRY), WILL BE ACCURATE, COMPLETE, OR ERROR-FREE.

YOU AGREE THAT YOU MUST EVALUATE ALL INFORMATION AND RESPONSES, AND THAT YOU BEAR ALL RISKS ASSOCIATED WITH, THE USE OF THIS SITE, INCLUDING ANY RELIANCE ON THE ACCURACY,COMPLETENESS, OR USEFULNESS OF ANY INFORMATION OR MATERIALS MADE AVAILABLE THROUGH THIS SITE.

Other users ask

Question
alk dip switch
warm boot cold boot
PIM retry settings
cannot enrol staff after power dip
cold boot dipswitch