vertical tail piece

RELATED FAQS

Question
Answer
Q330-168 SFIC Tailpiece (throw member for levers) Q330-169 SFIC Tailpiece (throw member for knobs) 
 The tailpiece of the rim cylinder can be inserted into the Von Duprin 98/99 rim device either vertical or horizontal.
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders.  Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces
If the 912L was shipped after February 28,  2011, Check the installation instructions, step 3 to be sure all parts are installed on the trim correctly, even if the trim was received in th...
The Schlage AD/CO trims are not compatible with the Falcon 25-V device due to the main cam on the device rotating the opposite direction for a given hand compared to the AD/CO trims output dri...
Below is the link to the document that shows how to install the AD993 tail piece assembly: Reinstalling an AD-993 Tailpiece Holder Assembly
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted.    This will occur if the outside spindle (square post) is install...
As of August 3rd, 2011 this is no longer an option.
The spacer (A508-640) is required to hold the cylinder in place due to the large size of the Orbit knob.
Types of astragal offered from Steelcraft are as follows: "Z" Astragal - For information on "Z" astragal types and attachment refer to the TD Manual page 3.3.17. Most commonly used on double ...