Schlage key way

RELATED FAQS

Question
Answer
CO Reader Modules are not individually replaceable, nor can they be swapped between locks. The inside and outside assemblies of a CO lock are a matched/mated set and cannot be swapped to change rea...
Schlage does not recommend cutting the L or LP section key blanks in the field.  Below are some details.Non Primus:In the classic family of keyways the "L" key section is the highest level key...
Schlage Everest 29 is a new keyway family that launched in August 2012 and is patented until 2029. It offers the highest level of restricted key system security by Schlage through patent protection...
1 1/8" mortise cylinders fit the 650 series keyswitch.  The 650 series keyswitch when ordered with the cylinder, will come complete with the correct cylinder, cam, and any required blocki...
If blocking rings (PN 36-079) are needed, specify dimensions when ordering. See below for blocking ring (PN 36-079) dimensions.  Blocking Ring  Specify Dimension  1//8" ...
It is not possible to key SFIC and standard cylinders including Schlage FSIC into the same system.  A keyway name may be shared between the two key fami...
The table below provides the Ilco cross reference to the Schlage keys.  Ilco Identification Section Pins Schlage Part # SC1 C 5 35-100 C SC4 C 6 3...
There are several Schlage and/or Falcon locks that have been tested and approved for this application. For Commercial use the locks have been tested and approved as assemblies wit...
Schlage and Falcon use the P cylinder suffix to designate conventional key-in-lever (KIL) 6 pin cylinder.  The D means that the lock will have a deadlatch.
To convert a Schlage ND80 to a ND70 you can replace the keycam or chassis and use your existing trim. Ordering Instructions: Keycam only: N123-010 Chassis and springcages: ND70LD LLL 626 LL...
Medeco does offer a key-in-lever cylinder to fit the Schlage ND.You will need to contact Medeco for the cylinderSpecify a key-in-lever cylinder to fit the Schlage ND lock.They will supply a cylinde...
For all Schlage and Falcon small format interchangeable cores shipped from the factory 0-bitted, the control key will be cut to all 4's.
Conventional Cylinders - A conventional cylinder is one that requires some breakdown of the lock in order to be removed. These are the most commonly used cylinders sometimes called key-in-lever...