Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
full size ic tailpiece
”
RELATED FAQS
Question
Answer
What is the part number for T lock tailpiece used with a conventional cylinder?
Resolution:
Refer to Table 1 for a list of T lock tailpieces for conventional cylinders. Table 2 shows IC tailpieces. Table 1: T lock conventional tailpieces Table 2: T lock IC tailpieces:
Can I get the T series with a Schlage Full Size Interchangeable core?
Resolution:
The T lock can accept a Schlage Full Size core, but the cylinder suffix must be specified as "J IC-SC" so the correct parts are supplied (including the tailpiece) Example: T581J IC-SC:
Will Falcon B locks prepped for BD accept a 6 or 7 pin core?
Resolution:
The B series accepts 6 or 7 pin small format cores when specifying with the "BD" cylinder suffix (less small format interchangeable core). The tailpiece shown below is used for bo...:
When ordering the ND lock less cylinder will it come with a tailpiece?
Resolution:
The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.:
I am unable to remove my key from a B600 B700 B800 deadbolt.
Resolution:
This is usually caused because the wrong tailpiece is being used on non-IC cylinders or the incorrect driver for IC options. Use the below descriptions to identify which they need.NON-IC: There are...:
How do you specify cylinder dogging for mortise cylinders?
Resolution:
XQ11-947 was used Classic conventional cylinders prior to the release of modular - NOW OBSOLETE:
What is the part number for a control pin for a 23-030?
Resolution:
There are two parts that can be referred to as control pins for a 23-030 (FSIC core).C603-967 is the lower control pin that sits in the seventh hole of the FSIC plug. (part B in exploded view) ...:
Why is the plug pulling out of the FSIC 23-030 mortise housing?
Resolution:
ISSUE: After some use the plug will begin to project from the cylinder face and will ultimately pull completely out. ROOT CAUSE: In a dogged application the cam was rotated 180 degrees which ...: