Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ DE-Series Double Egress Frame ”

RELATED FAQS

Resolution: It is the responsibility of the installing contractor to install all material in accordance with SDI or HMMA installation standards and tolerances. Out of square frames which are installed out...:

Can wood doors be used with with double egress frames?

Resolution: Yes, wood doors can be used and installed in most hollow metal frame applications including FE-Series and DE-Series Double Egress frames. Caution - For fire rated applications the wood door manufa...:

What is the difference between the FE and DE-Series frames

Resolution: A Double Egress frame is a double door frame prepared to receive two single-acting doors swinging in opposite directions (both doors are) the same hand. These openings are installed in cross corrid...:

Can DE-Series frames be prepared for pocket pivot hinges?

Resolution: Pocket pivot hinges are mainly used in cross corridor applications where clear opening width is a factor. For frames, pocket pivot hinges are a special hinge options which must be spe...:

Can fire rated double egress frames have side lights or transoms?

Resolution: No. Fire rated double egress frames must be a stand alone 3 sided frame assembly. If transom lights and/or sidelights are required, they must be built and installed as separate Fire Window assemb...:

What is the maximum size of a UL fire rated three (3) sided frame?

Resolution: Fire Rated three (3) frames are available in the following maximum door opening sizes: F and FN-Series frame:4' 0" X 10' 0" single door opening8' 0" X 10' 0” double door openingMU-Series frame...:

What is the rough opening in walls for frame installations?

Resolution: For DW, K three sided frames and four sided borrowed light frames: Three sided frame = door opening width (order size) plus 1 1/2" minimum to 2" maximum and the door opening hei...:

Can steel frames be installed after the wall board is installed in stud wall applications?

Resolution: DW and K-Series frames are designed to slip onto a stud wall after the wall is finished (painted, wall papered, etc).Walls can be either wood stud or steel studUsed only for interior appl...:

Can out of plumb (twisted) frames be adjusted?

Resolution: Out of plumb (also referred to as twisted) frames usually cannot be adjusted."Out of Plumb or Twisted frames (or jambs)" is a condition created by improper wall construction and/or improper in...:

Can "toed in" or "toed out" jambs be adjusted?

Resolution: This condition (toed in or toed out jambs) is usually not found until the door is installed.Frames which have toed in or toed out jambs have been installed out of tolerance.It is the responsibility...: