D lever insert

RELATED FAQS

Question
Answer
A control key is required to install or remove an interchangeable core from a housing or lever. The control key is identified by having "CONTROL" stamped on the bow. How to install and remove an i...
The old D-Series Lever used a standard lever insert similar to the pre-2002 AL-Series standard lever insert.  The old D Lever insert was smaller than the AL and the two were not comp...
There was a design change in 2001 for the driver and lever insert on the AL for SFIC products.  Changing the driver and/or lever insert on locks manufactured prior to 2001 will requi...
 The SFIC lever insert part number prior to 2001 was the A700-022.
The lever may be missing the slot feature for the core locking lug.  Verify slot is in place.
The Schlage Danmark levers are not available on the Von Duprin 996L lever trim.
The Exit Only (EO) device will accept any 19 Series trim as the main cam for the trim input is always put on the device center case.
The JD YA6 tailpiece is intentionally designed such that the tailpiece cannot be installed at the same time as the cylinder.  Interchangeable cylinders assume that the lever and taipiece is in...
See the JD Yale Lever installation instruction HERE