cylinder removal tool

RELATED FAQS

Question
Answer
Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig.  When the jig changed to...
To remove the knob:  Turn key 45 degrees clockwise Push in catch push pin and pull off knob  
*The older wafer style locks did not use a knob catch.  The chassis must be disassembled before the knob can be removed because it uses the wafer lock chassis spindle.
The cam screw uses a T-10 and the housing screws use a T-15 driver.
Schlage and Falcon double cylinder deadbolts have concealed screws to prevent tampering. The two methods used to conceal the thru-bolts are using screw caps or a faceplate. Use the below instructio...
The blue lever tool remover, 24002693, is not shipped in every box. The existing wire spring lever removal tool will be included in every box.  
The lever removal tool can be used to remove levers in both the ND and the L Series mortise locks.
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project.  This tool can be used for Schlage ND-Series ...
The current tools, pinning kits and key originating machines for all Schlage Everest full size cylinders and small format cores are the same used on Everest 29.
All lock cylinders on a specific project are operable by a special "project key".  Duplicates of this key may be assigned by the building contractor to workmen and subcontractors as required. ...
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...