Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ wiring instructions for el ”

RELATED FAQS

Question
Answer
How to wire 873-4TD to have 1 input trigger 2 EL devices?
To trigger two EL devices with one access input, wire your input into SC & I1, the first two screw terminals, then jump from I1 to I2 terminals.
How do I wire an EL device to normally hold open the latch and release it during a fire alarm?
Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted.  During a fire alarm, the contact will open, dropping...
What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?
  For Product Shipped Prior to August 2012 using the old (black) potted module: a.       0-100 ft 14 gauge wire b.      0-200 ft 12...
 
Is there a wiring diagram for EL and Von Duprin PS914-2RS power supply?
Reference The 914 Installation instructions.
Are the EL wiring harnesses still required with the new potted module?
EL wiring harness is no longer needed with new EL potted modules.
Does the QEL device come with the EL wiring assembly?
Yes, the QEL device includes a cable assembly part number 110388-00.Since 12/2014, that cable comes in a package (part 116549) with the long cable mentioned above and the small cable that plug...
Is the the PS914 EL wiring adapter needed for Von Duprin Chexit device?
The EL Wiring Adapter is not needed for a CX device.
Is the 900-ELK wiring adaptor required when using the PS914 power supplies?
Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or 900-...
Is the EL wiring adapter needed for QEL?
The EL wiring adapter is not needed for QEL devices.