Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Wire gauge run chart for EL Falcon ”

Resolution: For Product Shipped Prior to August 2012 using the old (black) potted module:a. 0-100 ft 14 gauge wireb. 0-200 ft 12 gauge wire&nbs...:

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

Why is the Von Duprin PS873 power supply buzzing or chattering?

Resolution: Some transformers in the power supplies provide a little humming noise and that is normal. If the humming in Von Duprin PS873 power supply is loud follow these steps. Remove the load from the outp...:

What gauge wire is needed for CX red and black power wires?

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

Does the wire size of an EPT affect the operation of an EL device?

Resolution: Since most wire transfer devices such as an EPT or electric hinges cannot provide large gauge wires, we take the small gauge wire into account when determining the overall wire size for the device....:

How many Von Duprin QEL devices can be connected to a power supply?

Resolution: Product Ordered before 7/10/2012 - Product identified by no label on QEL motor. You must use the 900-2Q option board with the PS900 power supplies to operate the QEL devices. The attached ta...:

What would make the PS914-2RS cycle on and off?

Resolution: The following could cause the PS914-2RS Power Supply to cycle on and off: The wrong wire gauge or run distance from power supply to the EL device. Click HERE for wiring requirementsOverlo...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Wire gauge run chart for EL Falcon ”

RELATED FAQS