Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ wide throw hinge with closer ”

Resolution: Standard templating will allow a 4110 closer to be mounted on 24" wide door.:

What is maximum width, height and weight for IVES butt hinges?

Resolution: Butt hinges can be used on doors up to 4' wide and 200 pounds. There is no maximum door height. However, an additional hinge must be installed every 30" when exceeding a 7' d...:

What is the narrowest door a 4010 can be mounted on?

Resolution: When templated for 140° the 4010 will fit on a 16-1/2" door leaf MINIMUM.:

Can you use a 4040SE with swing clear hinges on the pull side?

Resolution: Push Side Mount: Take the dimensions for the closer and track from centerline of swing clear hinge pin for the push side mount.:

What is a Cam Lift Hinge?

Resolution: Cam Lift Hinges are specially designed hinges used mainly on acoustical door assemblies. The Cam Lift Hinge lifts the door during its travel and seats the door bottom for a pos...:

Can I use a Glynn Johnson 410 with a 4040 regular (pull side) mount?

Resolution: ST-1630 is required when mounting a 4041 or 4040XP door closer regular (pull/hinge) side with a concealed GJ100 or GJ410 series over head stop.This ST also REQUIRES the use of a 4040-18TJ drop plat...:

Can a 4010 be mounted with swing clear hinges?

Resolution: Locate closer and arm from the centerline of the swing clear hinge pin.:

Can a Cam Lift hinge be used with LCN closers?

Resolution: Cam Lift hinges can only be used with LCN door closers that have a "Regular" or "Reg hold Open" style arm. Locating the Closer and Arm from the centerline of the pivot point of the cam lift h...:

What closer can be used with Soss invisible hinges?

Resolution: Using Soss hinges with closers can require special device and preparation locations. If you have questions on specific closer applications, please e-mail your request (including a description ...:

What degrees of opening can a 4110 EDA be templated for?

Resolution: The 4110 EDA/HEDA can be templated for 100°, 140°, and 180° hold open. The hold open adjustment can be set to hold the door at any position (degree) up to the maximum door opening angle. For "Wi...:

Can a 450 overhead be used on a 48" wide door hung with butt hinges or offset pivots?

Resolution: The 455 can be mounted on a 48" wide door, but we cannot guarantee that it will withstand the forces involved. Recommend using 906 instead.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ wide throw hinge with closer ”

RELATED FAQS