Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ “ where can i find electric power transfer template ” ”

RELATED FAQS

Where are hardware templates?

Resolution: All the templates can be found at us.allegion.com Please click here :

ELECTRIC POWER TRANSFER

Resolution: EPT, EPT-2, EPT-10 (EPT-1024, EPT-218):

ELECTRICAL POWER TRANSFER

Resolution: EPT, EPT2, EPT10 (EPT1024, EPT218):

Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

Where is factory recommendation for location of an EPT?

Resolution: EPT installation guidelines are as follows: Recommended location is 6" below top hinge per template Steelcraft will locate the power transfer prep at the Von Duprin re...:

What is the part number for the 6000 series electric strike 24VDC solenoid?

Resolution: The Von Duprin 6000 series electric strike can be converted by ordering the appropriate kits below. Kits include the solenoid, plunger, spring, and washer. 6000 Series solenoid Kit 1...:

What special template (ST) is used with a 4040(XP) Rw/PA mount closer and a GJ overhead stop?

Resolution: The use of a 62A Shoe (required) would be used to mount a 4040XP Parallel Arm with a "SURFACE" GJ 70, 79, 81, 90, or 450 series stop. You would order the 4040XP with a Reg w/62A arm op...:

Will a 4040 Hw/PA hold open at 180°?

Resolution: The 4041 Rw/PA and the Hw/PA have the same template. The only difference is the arm. The 4041/4040XP Hw/PA, if mounted to the 180° template, will hold the door open at 180°. Rw/PA is Regular A...: