Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ what size screws for nd series locks ”

Resolution: The part numbers are: N123-020 Mounting, all functions except ND170, Contains the following: (4) C603-897 (2) C603-256 (2) N523-021 (1) M504-271 N123-040 Mounting, ND170: Contains ...:

How do you order the ND series lock with a small format core?

Resolution: The letters GD, HD, BD, or BDC should be put after the lock function. EXAMPLE: ND53BD GD = Schlage SFIC core HD = Construction core BD = Less core BDC = Plastic temporary construction core:

What backsets are available on Schlage and Falcon locks?

Resolution: SCHLAGE locks are available with the following backsets: Lock Series Lock Type ...:

M400-Series Electromagnetic Lock - Cover Screw Size

Resolution: US 8-32 X 1/4 Inch length Phillips head. The same size can be used for a Torx/Security screw. :

How to convert a ND series lock cylinder format from PD to BD?

Resolution: On ND locks manufactured on or after January 30, 2017 only the SFIC lever and SFIC driver are needed to convert the lock from Full Size conventional (PD) or Full Size IC (JD, RD, TD) prep to S...:

What other locks can the blue lever removal tool 24002693 be used with?

Resolution: On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project. This tool can be used for Schlage ND-Series ...:

Does the Von Duprin E996L trim require the NL drive screw be installed into the device to function properly?

Resolution: Von Duprin 98/99 NL drive screw is located in back of the 98/99 center case assembly. NL drive screw should be left in with trim lock slide plate in up position in the 98/99 exit device with E99...:

What is the part number for the full size core driver for the ND series?

Resolution: The ND-Series FSIC driver is part number N523-127.:

What is the size of the ND series rose?

Resolution: The diameter of the ND rose is 3 7/16".:

Is there a tool to drill the thru bolt holes on cylindrical locks?

Resolution: Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig. When the jig changed to...:

What type of switch is used for the RX and latch monitoring options for the ND and L locks?

Resolution: The ND-Series RX, the L-Series RX and latch monitoring switches are Form C - Single Pole Double Throw (also known as SPDT).:

What height should a lock or deadbolt be installed?

Resolution: According to ANSI specifications for cylindrical or mortise locks: The lock strike centerline should be 40 5/16" from the bottom of the frame with the lock in relation to the strike.&...:

Can you explain the ND53 function?

Resolution: ND53PD (ANSI F109) Entrance Lock Turn/push-button locking; pushing and turning button locks outside lever, requiring use of key until button is manually unlocked. Push-button locking; pushing ...:

How does the ND82 operate?

Resolution: ND82PD (ANSI F87) Institution Lock Both levers fixed. Entrance by key in either lever.:

What are the part numbers for the ND lock spring cages?

Resolution: ND-series locks manufactured before January 30, 2017 used the following spring cages::

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ what size screws for nd series locks ”

RELATED FAQS