Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ what PS is needed for EL device? ”

RELATED FAQS

Resolution: The PS861 will not power an EL device. The high 16Amp current of the EL requires the PS914-2RS, PS914-4RL or the older PS873-2 power supply to operate.:

How many Von Duprin QEL devices can be connected to a power supply?

Resolution: Product Ordered before 7/10/2012 - Product identified by no label on QEL motor. You must use the 900-2Q option board with the PS900 power supplies to operate the QEL devices. The attached ta...:

What is the purpose of the 900-2RS board?

Resolution: The 900-2RS option board is used with PS914 power supply to isolate the inputs such as key pads or card readers from the outputs for EL electric exit devices. The EL draws 16 amp inrush that needs...:

Does the wire size of an EPT affect the operation of an EL device?

Resolution: Since most wire transfer devices such as an EPT or electric hinges cannot provide large gauge wires, we take the small gauge wire into account when determining the overall wire size for the device....:

Is the the PS914 EL wiring adapter needed for Von Duprin Chexit device?

Resolution: The EL Wiring Adapter is not needed for a CX device.:

Does the PS914-2RS x EL device have time delay?

Resolution: The PS914 x 900-2RS option board doesn't have time delay. If time delay is required specify PS914 x 900-4RL. 900-4RL provides up to 75 seconds, 5 second increment unlock time.:

How many EL devices can be operated from the PS 914?

Resolution: You can operate two EL devices with PS914-2RS, up to four with PS914-4RL and up to eight with PS914-4RL-4RL with limited distance from power supply to the EL devices.:

Would the 900-4R option board control EL devices in a PS914?

Resolution: The 900-4R is used with PS900 series power supplies and has four independent outputs and inputs with no time delay. You can use any of these outputs with electrified hardware including EL devices a...:

Will the 900-2Q option board operate an EL device?

Resolution: The 900-2RS is recommended to be used with EL devices but if you have a 900-2Q with PS914 power supply it can be used to operate up to two EL or one EL and one QEL devices .:

What could cause the fuse to blow in a PS873 power supply?

Resolution: Following could cause the fuse to blow in Von Duprin PS873 power supply. PS873 power supply provides 2AMP at 24VDC or 4AMP at 12VDC. If this limit is exceeded the fuse will blow in the power sup...: