Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ What is bored locks? ”

RELATED FAQS

Resolution: Grade 1 locks are tested and certified to be in compliance with the following ANSI/BHMA Standards: Cylindrical, Bored and Preassembled Locks & Latches 8...:

What is a Grade 2 Lock?

Resolution: Grade 2 locks are tested and certified to be in compliance with the following ANSI/BHMA Standards: Cylindrical, Bored and Preassembled Locks & Latches 400,000 Certified Cycles ANSI...:

What is the minimum rose dimension that can be used with a Steelcraft 61L lock preparation?

Resolution: The minimum rose that can be used on the 61L (ANSI/BHMA A156.115.18) preparation is 3 7/16".Steelcraft's 61L lock prep (often referred to as the "Squashed Turtle lock prep") is designed for Bored L...:

What is a mechanical Lock?

Resolution: A lock is any device which prevents access or use by requiring special knowledge or equipment. Mechanical locks are mechanical devices which secure an opening by keeping a door closed until a rel...:

What is a cylindrical lock?

Resolution: Cylindrical Locks: a bored lockset whose latch or bolt locking mechanism is contained in the portion installed through the cross-boreMedium, high to extra heavy dutyCommercial, multi-family and ins...:

Is there a tool to drill the thru bolt holes on cylindrical locks?

Resolution: Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig. When the jig changed to...:

What is the center to center for the Falcon H lock?

Resolution: The dimension between the center of the deadbolt bore and the knobset bore is 4". See template FH100 attached here for more dimensions.: