Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ warrenty on door closers ”

Resolution: The holding force on an SE/ME Series door closer is approximately 35 lbs. and they can be manually pulled out of hold open with approximately 35 lbs of force. :

Where are hardware templates?

Resolution: All the templates can be found at us.allegion.com Please click here :

Can the 4630/4640 cylinder only be replaced?

Resolution: The 4040(XP) door closer can be used as a temporary replacement in a 4630/4640 operator to provide manual control of the door while the 4630/4640 closer cylinder is being repaired or a replacement ...:

Can you order a 1461 cylinder only?

Resolution: The part number is: 1461-3071 for the door closer cylinder body.:

What special template (ST) is used with the 2030 closer and a low profile track and roller?

Resolution: The 2030 closer requires a minimum 1-3/8" top rail on the door for the standard track. For a top rail less than 1-3/8" and as narrow as 1", you could use the l...:

In what direction should the hold open nut be pointing for a 4041 H closer, up or down?

Resolution: Make sure that the hold open nut is not on upside down. The orientation of the hold open nut depends on the mounting. On a Top Jamb "Push Side" mount, the hold open nut would poi...:

What is a 62A shoe used for?

Resolution: The 62A shoe is used when it is necessary to install the door closer (lower) down on the door so that it will operate under accessories such as overhead stops, coordinators, etc.:

Can a 4010 be mounted with swing clear hinges?

Resolution: Locate closer and arm from the centerline of the swing clear hinge pin.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ warrenty on door closers ”

RELATED FAQS