Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ von duprin guard x test instructions ”

Resolution: Replacing the battery on the 2670 should not cause the unit stop working. Make sure the spring that provides tension on the plastic finger is not bent out. The spring should be at a 90 degrees...:

Is the Von Duprin Guard-X exit device fire rated?

Resolution: The Von Duprin Guard-X exit device is not fire rated because the deadbolt is not spring loaded. Therefore, there would be no positive latching as required on a fire rated opening. :

What exit device is weather rated?

Resolution: Exit devices are not designed for exterior application. If used in an exterior applications then a powder coated finish on the 33/35 and 98/99 series are recommended for exterior applications. ...:

How to replace the circuit board or horn on a Guard-X device?

Resolution: See PCB replacement instructions below. The horn is part of the board and can only be replaced by replacing the entire board.:

Can the 2670 be cut down to fit smaller door widths?

Resolution: The 2670 Guard X device can't be cut down to fit doors less than 3 feet. This device is designed to fit doors 36"-48" door width.:

Does Von Duprin offer any pulls that through bolt to the Guard-X device?

Resolution: Von Duprin does not offer any lever trim or pulls that through bolt to the Guard X device. Ives has the 8102-6 and 8105-6 pulls that can be lined up with the mounting screws of the exit device b...:

Is there an electric strike that will work with the 2670 Guard X?

Resolution: The Von Duprin 2670 Guard X does not have a spring loaded latch bolt, it is a dead bolt and will not operate with any electric strikes.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ von duprin guard x test instructions ”

RELATED FAQS