Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ VON DUPRIN DOOR PULL ”

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

Does the Von Duprin CX 98/9975 allow lever entry from the pull side without sounding the alarm?

Resolution: As long as there is no door position switch wired to the CX the outside trim will work as it would on a standard 98/9975 device. :

Does Von Duprin offer any pulls that through bolt to the Guard-X device?

Resolution: Von Duprin does not offer any lever trim or pulls that through bolt to the Guard X device. Ives has the 8102-6 and 8105-6 pulls that can be lined up with the mounting screws of the exit device b...:

Can you manually pull a 4040SE out of hold open?

Resolution: The holding force on an SE/ME Series door closer is approximately 35 lbs. and they can be manually pulled out of hold open with approximately 35 lbs of force. :

What side of the door is the 4040SE mounted?

Resolution: The 4040SE is non handed and can be mounted on the push or pull side of the door.Installation Instructions :

Can a 4041 EDA be mounted top jamb?

Resolution: The 40401/4040XP closer with optional EDA arm has to be mounted parallel arm on the push side of the door.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ VON DUPRIN DOOR PULL ”

RELATED FAQS