Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Voltage monitor is low when should be high ”

Resolution: If the Main AC fuse is blowing, the control box is defective and needs to be replaced. The "Main Fuse" is a (5x20MM) 1 Amp Slow Blow fuse. If the 12VAC fuse is blowing, verify they are not trying...:

Why do AD Series offline locks still give a Low Coin Cell indication after I install a new coin cell?

Resolution: The coin cell part number is CR2025 - 3 volt lithium - available at most battery or electronics stores.:

What is the low battery threshold for the AD and CO Locks?

Resolution: CO200 & CO250 Disable coin cell Nuisance delay and blink, With CO.A.7 and SUS 4.10.2 or newer for CO200 and CO250, you can use the SUS/HHD, under Lock Properties, Edit, to de-select, DISABLE, t...:

What actuators can be used on the 8310-866 Bollard post?

Resolution: The LCN Bollard post (8310-866) only accepts the "square" actuators (no round actuators). The size of the Bollard post is 4” X 6” X 36”. Acceptable actuator part numbers are: Hard Wired - 831...:

Magnetic Stripe Card Coersivity

Resolution: Magstripes come in two main varieties: high-coercivity (HiCo) at 4000 Oe and low-coercivity (LoCo) at 300 Oe but it is not infrequent to have intermediate values at 2750 Oe. High-coercivity magstri...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Voltage monitor is low when should be high ”

RELATED FAQS