Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ vertical bar guard ”

RELATED FAQS

Resolution: Exit devices are not designed for exterior application. If used in an exterior applications then a powder coated finish on the 33/35 and 98/99 series are recommended for exterior applications. ...:

What is the part number for the pcb board on the 2670 Guard X exit device?

Resolution: The following are part numbers for 2670 Guard X exit device PCB: pcb.10018 for English pcb.10019 for Spanish pcb.10020 for French:

What strike is required when using the 2670 Guard-X on a pair of doors?

Resolution: With a mullion: Use the standard strike 267 With no mullion and inactive leaf being held closed with flush or surface bolts: Use the 2609 double door strike :

After replacing the battery on a Von Duprin 2670 Guard X why would the horn stop working?

Resolution: Replacing the battery on the 2670 should not cause the unit stop working. Make sure the spring that provides tension on the plastic finger is not bent out. The spring should be at a 90 degrees...:

How long is the RGO?

Resolution: The RGO (rod guard only) is 36" long x 1-5/8" wide.:

Can the 2670 be cut down to fit smaller door widths?

Resolution: The 2670 Guard X device can't be cut down to fit doors less than 3 feet. This device is designed to fit doors 36"-48" door width.:

Is there an electric strike that will work with the 2670 Guard X?

Resolution: The Von Duprin 2670 Guard X does not have a spring loaded latch bolt, it is a dead bolt and will not operate with any electric strikes.: