Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ using LX for RX ”

Resolution: PN33/35/98/99 Pneumatic exit devices are not usually used with RX or LX switches since the Pneumatic PN device is used instead EL to eliminate the electric from the device.:

What power supply is used with RX or LX switches?

Resolution: The RX switch is request exit and the LX switch is latch bolt monitor switch. They do not require a power supply directly. The electrified hardware that the RX or LX switch...:

Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

What is the difference between Von Duprin LX and/or RX switches and the Signal Switch SS option?

Resolution: The RX monitors the push bar while the LX monitors the latch bolt of the exit device. A SS device has an LX and a key cylinder switch plus an emergency push bar signage.:

Can you add the LX option to a Von Duprin device that already has the RX option?

Resolution: The Von Duprin RXLX combination switch must be ordered together as one assembly. Existing RX or LX switch must be removed to install the combination RX LX switch. Make sure correct RX LX combinatio...:

What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?

Resolution: The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ using LX for RX ”

RELATED FAQS