Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
triangles lined up
”
RELATED FAQS
Question
Answer
Why does the Schlage button light up “Green” when I open the door?
Resolution:
When unlocking the CO200 door by mechanical key override, the green led will be continuously ON until the key is released. This will occur after firmware CO.A.6 (or later) has been installed int...:
Why is my HHD not connecting to my AD lock?
Resolution:
5) If working with a CO lockset, the mechanical key switch needs to be in its "Inactive" or normal position. Ensure the triangle alignment on the front escutcheon and that...:
The Hand Held Device (HHD) or Schlage Utility Software (SUS) will not connect to the CO200?
Resolution:
Make sure the HHD/SUS is set to USB communication by checking the small icon right of the "No Device Connected" message. The symbol should be a USB symbol when working with USB enable product...:
Why does my AD or CO series lock unlock when the lever is raised?
Resolution:
Installers have reported that their AD-CO Series cylindrical or mortise locks will unlock whenever the outside lever is lifted. This will occur if the outside spindle (square post) is install...:
I get three green blinks of the Schlage key and it says motor stall on my SUS/HHD during diagnostics?
Resolution:
Just align the triangles per the installation instructions to allow full motor movement. - This will eliminate the SUS motor STALL report. - This will eliminate the three ...: