Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Top latch does not drop ”

Resolution: Check the adjustment and if this does not resolve then you may possibly have a defective center case or bottom latch.:

What would cause an EL device to pull and release?

Resolution: If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:

What would keep the vertical rod exit devices top latch from being held retracted in the open position?

Resolution: Following exit devices 2227/F, 33/3527A/F, 33/3547A/48A/F, 98/9927/F and 98/9947/48/F have similar rod adjustment procedures. All top latches control the bottom latch assemblies. When do...:

Why is the 2390 top latch not staying retracted when dogged?

Resolution: Most likely need to length the top rod so latch can engage it's internal latch retention state. See 2390 Instructions for adjusting rod lengths.:

What would cause the Von Duprin 88 series exit device latchbolt not to extend and the crossbar to droop?

Resolution: The spring in the hinge case or end case assembly lifts the crossbar and both lever arms. If broken, the crossbar and lever arms will drop down. The weight of the crossbar and levers will automati...:

What is the part number for the 5547 top latch non rated?

Resolution: The part number for 5547 top latch and rod assembly is 050053-00. :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Top latch does not drop ”

RELATED FAQS