Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ STEELCRAFT DOOR HARDWARE LOCATION ”

RELATED FAQS

Resolution: The use of Panic Hardware and/or Fire Exit Hardware is required by the International Building Code (IBC) and NFPA 101 – The Life Safety Code, depending on which code and which edition of the code i...:

Can a door have an INPACT device and glass lights?

Resolution: Glass lights available:Standard Glass Lights - The N4, N5 & V lite can be used at standard locations without any modification.Glass Light Options - Other glass lights are available but have lim...:

What is the maximum size for a Dutch Door?

Resolution: Maximum Dutch Door sizes are:Non Labeled = 4'0" wide X 8'0" HighLabeled = 4'0" wide X 7'2" HighSpecial sized Dutch Doors are available:Special size top and/or bottom leaves are available.When order...:

What door meets FBC / NOA Zone 4 requirements?

Resolution: H-Series doors in single leaf applications with only mortise locks meet the FBC / NOA Zone 4 requirements?3070 max flushOutswing & Inswing applicationsZone 4 requires 120 to 170 psf.:

What is the factory recommended location for an EPT?

Resolution: EPT installation guidelines are as follows:Recommended location is 6" below top hinge per template.Steelcraft will locate the power transfer prep at the Von Duprin recommended template location of ...:

Where is the Fire Label located on a door and a frame?

Resolution: Fire labels (UL, ITS/WHI or FM) are located as follows: Butt Hinges and Pivots: On the doors the fire label is located on the hinge edge between the top and 2nd hinge preparation. On the fram...: