Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Standard DeadBolt locations
”
RELATED FAQS
Question
Answer
How to remove a double cylinder deadbolt?
Resolution:
Schlage and Falcon double cylinder deadbolts have concealed screws to prevent tampering. The two methods used to conceal the thru-bolts are using screw caps or a faceplate. Use the below instructio...:
Where are hardware templates?
Resolution:
All the templates can be found at us.allegion.com Please click here :
Where is the Deadbolt Monitor, Latchbolt Monitor, RX Switch, EL/EU Switch and Motor Assembly located in an L9000 Electrified Lockcase?
Resolution:
The Lock Case above is shown with the Simultaneous Retractor in place.:
Will the Von Duprin 6210 electric strike operate with the MA series locks?
Resolution:
The Von Duprin 6210 electric strike was designed for retrofit applications and will not work with the Falcon MA series lock when strike and lock body are mounted at standard locations (centerline o...:
Where is the EPT location of a Pin-and-Barrel Continuous HInge?
Resolution:
The 600/700 Series EPT Template shows recommended locations based on the standard sizes, The customer can provide a different dimension measured from the top of the hinge to the Cen...:
Where is factory recommendation for location of an EPT?
Resolution:
EPT installation guidelines are as follows: Recommended location is 6" below top hinge per template Steelcraft will locate the power transfer prep at the Von Duprin re...: