Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Solenoid Electric Latch Retraction Power Supply ”

Resolution: The resistance readings for a Falcon 24 or 25 Series EL solenoid should read;Green to Yellow = Pull Coil, should measure between 1 and 2 ohms of resistance. Green to Orange = Hold Coil, s...:

How do I wire an EL device to normally hold open the latch and release it during a fire alarm?

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

Is there an EL conversion kit for the Falcon 2390 exit device?

Resolution: There is no EL conversion kit for a 2390, the device will need to be replaced.:

Can the Von Duprin EL option be added to any existing 98/99 device?

Resolution: The Von Duprin EL option can be added to any existing 33A/35A, 98/99 series exit devices. :

How does the latch bolt retract on the Von Duprin XP device?

Resolution: The latch bolt on an XP98/99 exit device does not retract. The latch bolt will release and pivot out of the way when push bar is depressed or out side trim is activated.:

Is a Von Duprin or Falcon EL device available in 12V?

Resolution: Electric latch retraction, EL, devices are only available in 24VDC. (Note: The EL option for 24/25 series and related service parts have been discontinued as of 7/25/2022):

What wire gauge and run is recommended for Von Duprin electric latch retraction EL device?

Resolution: :

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Solenoid Electric Latch Retraction Power Supply ”

RELATED FAQS