Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ sentronic not holding ”

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...:

What causes am ME Series closer to creep shut (creeper)?

Resolution: If an ME Series closer creeps shut or will not hold open, Verify proper voltage is being supplied to the closer, if correct Check the on/off switch. Verify the voltage on the 2 pin co...:

What are Hold Open Closers & Magnets?

Resolution: Hold Open Closers & Magnets (Fire/Life safety products) provide a wide range of solutions. Single or multi-point hold open closers Utilize an electromechanical closer. Hold the door o...:

SENTRONIC

Resolution: General term for the fire/life safety products offered by LCN.:

Why would an EL1690 retract the rods but not hold them?.

Resolution: One of the following items may cause the EL1690 device to retract then release: Incorrect power supply - Verify you have the PS873-2/4TD or PS914-2RS/4RL power supply. Problems with wire gauge...:

What can I do if my biometric GT-400 isn't keeping the time?

Resolution: First of all, measure the voltage of the coin battery, while still installed in its white plastic holder on the main board ( to find its location, please see lithium battery installation guide )&nb...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ sentronic not holding ”

RELATED FAQS