SEE FINISH COLORS

RELATED FAQS

Question
Answer
Factory finished painted doors are available from Steelcraft. Frames "are not available" factory finished from the factory. Doors are offered in variety of standard colors or can be fini...
Beginning December 6, 2010, all 33A, 35A, 98 & 99 devices ordered as 313AN Anodized was furnished in SP313 (dark brown powder coat).  All devices ordered as 315AN wil...
The current Powder Coat finishes are: Aluminum (BHMA 689) Dark Bronze (BHMA 695) Brass (BHMA 696) Light Bronze (BHMA 691) Statuary Bronze (BHMA 690) Black (BHMA 693)For list of standar...
Tan Powder Coat can be ordered but only available as a special finish with a metal cover.
White Powder Coat can be ordered as a special RAL finish with a metal cover.
For custom powder coat (LCN RAL customer powder coat colors) guide/chart please see here.
With the new FW package 2.19.0; AD300 FW 2.17.0 and AD400 FW 2.17.0 (released 09/23/2011) the firmware looks for a motor clutch switch change after a motor move command. If there is no motor clutch...
If the triangles in the spring cage spindle are not aligned properly the motor will not move enough to change the clutch switch. Is is very likely with a lock on the bench; but a properly install...
When the new firmware moves the motor three times without seeing the clutch switch change it reports to the SUS diagnostics that the motor is stalled. Aligning the triangles will let the motor move...
If the lock is mounted on the door, it is necessary to adjust the mortis/cylinder tightness and spring cage tailpiece alignments, making sure there is no binding or stopping of the spring...
Just align the triangles per the installation instructions to allow full motor movement.   - This will eliminate the SUS motor STALL report. - This will eliminate the three ...
The 643e is a powder coat finish equivalent to the US11 aged bronze finish.  The 613 is oxidized and oil rubbed and is equivalent to the US10B.
Close up of the copper relieved edges on 643e
Thermal Bow is a temporary condition which occurs in metal doors mainly due to the temperature differential from one side of the door to the other. This may occur in exterior doors when direct sun ...
As of June 2011 the electrified T locks can support 12 or 24 Volts.  You do not need to specify 12 or 24 when ordering since the solenoid is capable of either voltage out of the...
Prior to June 2011 the T lock only supported 24V and the electrical requirements were as follows: 0.185 amp @ 24VDC Wire Gage 22 AWG See wiring diagram here - (Previous 2 wire versi...