Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
SCHLAGE LEVER SERIES
”
RELATED FAQS
Question
Answer
Is the Schlage Latitude and Longitude lever available in a stainless steel finish?
Resolution:
Beginning January 2, 2013 Schlage will offer the Latitude (LAT) and Longitude (LON) levers in the 629 and 630 stainless steel finishes.:
What other locks can the blue lever removal tool 24002693 be used with?
Resolution:
On August 15, 2012 Schlage began shipping a new, more ergonomic, lever removal tool to coincide with Phase 1 of the ND-Series improvement project. This tool can be used for Schlage ND-Series ...:
What was the part number for the old D series levers spring cage?
Resolution:
The old D series springcage part numbers are as follows: C303-035 - Inside Springcage C303-036 - Outside Springcage These parts are no longer available.:
What is the difference between the standard lever inserts for the pre-2002 AL and the old D Lever?
Resolution:
The old D-Series Lever used a standard lever insert similar to the pre-2002 AL-Series standard lever insert. The old D Lever insert was smaller than the AL and the two were not comp...:
Are there parts available for the old D lever locks?
Resolution:
The D lever was discontinued in October 2003 and there are no parts available.:
Does the PD listed with lock model number mean anything?
Resolution:
Schlage and Falcon use the P cylinder suffix to designate conventional key-in-lever (KIL) 6 pin cylinder. The D means that the lock will have a deadlatch.:
What is the ME9453?
Resolution:
At one time we offered a 9453 function in several different lever, knob and grip handleset designs. A wide variety of trim offerings were available. The mortise lockcase was a smaller version of th...:
Can the Schlage Latitude levers be used with the 98/99 series?
Resolution:
The Schlage Latitude levers can't be used with Von Duprin 98/99 series exit devices.:
Can I put a Schlage Key-In-Lever cylinder into a Falcon D100 or D200 lock?
Resolution:
For a Schlage "C" keyway: Specify "CP6" as the cylinder suffix when ordering D100 or D200 locks (All other Schlage keyways are not available).:
What grade of stainless steel do we use in the levers on L9000 locks?
Resolution:
Schlage offers 629 and 630 stainless finishes on levers for the L-Series only. These levers are made of 303 or 304 grade stainless steel.:
Why does the Schlage button light up “Green” when I open the door?
Resolution:
When unlocking the CO200 door by mechanical key override, the green led will be continuously ON until the key is released. This will occur after firmware CO.A.6 (or later) has been installed int...: