Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
SCHLAGE CO SERIES EXIT TRIM
”
RELATED FAQS
Question
Answer
Do we offer a lever trim with squared top and bottom for the 98/99 series exit devices?
Resolution:
The Von Duprin 994L series trims were square on top and bottom. They were discontinued in July 2010.:
What trim will work with the discontinued Monarch18 series exit devices?
Resolution:
Falcon Monarch XX series trims will work with Monarch 18 series exit devices.:
Does Von Duprin supply the 9875, 9975, 9875-F and 9975-F mortise exit devices with NL-OP trim function?
Resolution:
For night latch function with pull by others, the 98/99 series mortise exit device should be ordered as NL less trim, e.g., 9875NL-L/TRIM. We will furnish a device only, and the mortise cyl...:
Can the Falcon Monarch 718C or 718NL trim be used with the 25-C exit device?
Resolution:
The Falcon Monarch 718C and the 718NL trims can be used on the 25-C exit device. The 718C trim is listed in the Price Book for the 25 series The instructions attache...:
When pairing with a Schlage AD or CO exit trim, how should the 98 or 99 series exit device be ordered?
Resolution:
The device may be ordered as EO, exit only. That device will have the components needed to interface with the AD and CO exit trim.:
Which exit devices work with the AD-Series exit trims?
Resolution:
Falcon 25 Rim exit device is compatible with AD200 and AD250-993 exit trims.:
Why doesn't full rotation of the AD or CO Series Exit Trim (993) outside lever fully retract the Von Duprin 98/99 Exit Device latch?
Resolution:
- AD Series and CO series products require that the Night Latch (NL) screw is installed in the exit device. Be sure this screw is installed- Exit hardware and strike must be properly mounted ...:
Is the AD CO with a 993 chassis compatible with the Von Duprin 33A exit device?
Resolution:
No, the 33A is not compatible with the AD and CO 993 chassis units. The 33A can only be driven in a clockwise direction. This would restrict it to right hand installs only.:
Does any of the Ives VR trims work with non-IR exit devices?
Resolution:
You will need to check with the other manufacturer. Check the template for the other manufacturer to see if the hole pattern for the trim and the cylinder location would match up. The VR trim cou...:
Will the new 712L work with old 17 series?
Resolution:
The 24 series & older 17 Series trims are compatible with each other.: