Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ RX KIT WIRING INSTRUCTIONS ”

Resolution: For solenoid driven Chexit devices shipped from the factory prior to 8-24-2015, the RX switch is no longer available. This part was discontinued in 2019.If the RX Switch of a solenoid driven ...:

What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?

Resolution: The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.:

Can you field install a RX switch on the 24/25 device?

Resolution: The RX switch can be installed at the factory when device is ordered or in the field with part# 650359-00. Installation instructions here will show how the RX swi...:

Is there a template that shows where to drill the hole for E/EL/SS/RX/LX/CX wires?

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

What are the 3 wires on the Falcon EA, exit alarm switch?

Resolution: For 24/25 devices per instructions : Violet - Normally Open Black - Common Gray - Normally Closed:

Is there an Exit Alarm Retrofit Kit (EAK) for the 19 series?

Resolution: These kits for the 19 Series were discontinued June 11th, 2012 when the updated alarm kit for the 24/25 series was released. Prior to discontinuation, it was o...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ RX KIT WIRING INSTRUCTIONS ”

RELATED FAQS