Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ rw/pa back check ”

Resolution: The Rw/PA arm is simply a regular arm that is packed with a 62PA (parallel arm) shoe, which will allow a (Tri-Pack) closer to be mounted in a regular, top jamb, or parallel arm application.:

What drop plate is used with a 4040 Rw/PA?

Resolution: The 4040 Rw/PA can be mounted 3 different ways. The 4040-18 drop plate is used for the regular pull side mount. The 4040-18TJ drop plate is used for the top jamb push side mount. The 4040-18P...:

What do I need to do to make my 4041 Reg/PA a hold open arm?

Resolution: When placing an order for a 4041/4040XP Rw/PA with hold open, it would be ordered as a 4041 /4040XP Hw/PA. For an existing Rw/PA requiring the addition of a hold open function, a hold open arm woul...:

Will a 4040 Hw/PA hold open at 180°?

Resolution: The 4041 Rw/PA and the Hw/PA have the same template. The only difference is the arm. The 4041/4040XP Hw/PA, if mounted to the 180° template, will hold the door open at 180°. Rw/PA is Regular A...:

How much top rail is needed on a 4041 REG/PA (Rw/PA)?

Resolution: To install a 4041/4040XP with Rw/PA or Hw/PA arm, you need a minimum of 5-3/8" top rail on the door, measured from the bottom of the stop. If the top rail is less than 5-3/8", you will need to use ...:

What is the minimum top rail required on a door for 1461 Rw/PA?

Resolution: The 1461 Rw/PA requires a 4-3/8" minimum top rail on the door without the use of a drop plate. If top rail is less than 4-3/8" a 1460-18PA drop plate will have to be used.:

What special template (ST) is used with a 4040(XP) Rw/PA mount closer and a GJ overhead stop?

Resolution: The use of a 62A Shoe (required) would be used to mount a 4040XP Parallel Arm with a "SURFACE" GJ 70, 79, 81, 90, or 450 series stop. You would order the 4040XP with a Reg w/62A arm op...:

RW/PA

Resolution: Regular Arm with Parallel Arm Shoe:

Camera calibration on a hand reader, what should the row (r), column (c), and exposure (e) calibration values be to indicate proper camera alignment?

Resolution: On a biometric F-Series or E-Series hand reader, the desired row (r) value and column (c) value should each be zero (0), plus or minus 2. The desired exposure (e) value sh...:

How does the RU/RM check and update its internal time?

Resolution: It should get a command from ACP and GWE will push the update to the device.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ rw/pa back check ”

RELATED FAQS