Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
RIM tailpiece break away
”
RELATED FAQS
Question
Answer
Can the 88 device be ordered as NL-OP?
Resolution:
You would have to order the device as 88NL less trim, the device will be shipped as an 88EO. The EO device has an NL cam to accept a rim cylinder tailpiece. :
The key just spins on a B560R B561R or B563R deadbolt.
Resolution:
The Schlage full size interchangeable core (FSIC) prepped B560F, B561F, and B563F deadbolts all require a UL fire cup (R) in order to be UL listed. This fire cup is s...:
What is a 7910-967?
Resolution:
The 7910-967 is a part number for a discontinued RF actuator. It was replaced by the 8310-3856WS RF actuator. The new 8310-3856WS requires the use of an 8310-865 RF receiver. When replacing the ol...:
What is the part number for the Schlage small format rim cylinder tailpiece?
Resolution:
B502-899 is the tailpiece for both the SFIC and standard rim cylinders.:
What is the tailpiece and driver part number for the 20-057?
Resolution:
The B220-001 is an FSIC rim tailpiece and driver.:
Which way is the tail piece of the rim cylinder is inserting into the Von Duprin 98/99 rim device from 996L trim?
Resolution:
The tailpiece of the rim cylinder can be inserted into the Von Duprin 98/99 rim device either vertical or horizontal.:
What is the length of a Schlage rim cylinder?
Resolution:
The Schlage rim cylinder lengths are given below and were measured from the face of the cylinder to the back of the tailpiece. Because of allowable tolerances for each part the average length is l...:
What is the maximum door thickness a Rim cylinder can fit on?
Resolution:
For total thickness measurements larger than 3 inches see the special cylinder offerings in the Schlage Pricebook. Specify the part number and include the total thickness. We do no...:
What is the break-away point for the Schlage SL1 ligature resistant trim?
Resolution:
The Schlage SL1 ligature resistant lever is designed to break-away between 100 and 200 inch-pounds. The lever will rotate at this point but not allow access.:
Can you use a new 812L on an old bar that had a 182L?
Resolution:
The current 812L trim will replace the older 182L trim. Due to the thicker escutcheon plate of the 812L trim a 1 1/2" mortise cylinder with straight cam for mortise devices or a longer rim cylinde...: