Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
releasing too soon
”
RELATED FAQS
Question
Answer
Can a Chexit release delay time be changed in the field?
Resolution:
The release delay time for the Chexit is programmed into the Chexit module and cannot be changed in the field.The ability to change the delay time is restricted by the UL listing of the device.&nbs...:
I replaced the CT5000 coin cell, but I still get a Low Battery indication.
Resolution:
Coin Cell part number is CR2025 - 3Volt Lithium - available at most any battery store.:
What is the difference between Panic Hardware and Fire Exit Hardware?
Resolution:
The most obvious difference (in the device) is the lack of mechanical dogging on a Fire Rated Device. There are some internal parts that may be different and the method it is secured to the d...:
Why do AD Series offline locks still give a Low Coin Cell indication after I install a new coin cell?
Resolution:
The coin cell part number is CR2025 - 3 volt lithium - available at most battery or electronics stores.:
Hand Reader just stops communicating via Ethernet?
Resolution:
When the Ethernet communications suddenly stop working on a biometric hand reader, there is the set of questions to ask the customer to start the troubleshooting process. They are detail orie...:
When did they start putting the green dial's on the 4041 closers?
Resolution:
LCN started putting on the green dials for the spring adjustment on the 4041's in 2001.:
What would cause an EL device to pull and release?
Resolution:
If your Von Duprin EL (solenoid) device pulls and releases quickly instead of holding the latch retracted, please check all of the items below.In most cases, one or more of these solutions will r...:
What would cause an EL exit device to pull and release repeatedly?
Resolution:
Following could cause the EL device to pull and drop repeatedly. Short to ground on EL wiring. Incorrect wire gauge used. For wire run and gauge requirements, click HERE Wrong power suppl...:
Why will my EL 1490 fire my latches but not hold?
Resolution:
One of the following items may cause the EL1490 device to retract then release: Incorrect power supply - Verify you have the PS873-2/4TD or PS914-2RS/4RL power supply. Problems with wire gauge...:
What would cause the Von Duprin EL Solenoid not to hold when the mech case cover plate is slid over top of the solenoid?
Resolution:
If the cover plate on the mechanism case causes the EL solenoid to drop when slid over the solenoid, then the solenoid plunger requires adjustment. You must lengthen ...: