Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ qel rx device power supply ”

RELATED FAQS

Resolution: No, you can only add one 900-2Q option board to the PS902 power supply and 900-2Q only can support two QEL devices.:

Will the MPB-842 or MPB-840 power EL or QEL devices?

Resolution: The old MPB842 power supply will power up to two EL electric panic bars but will not power the QEL devices. A defective potted module inside the electric panic bar or defective power supply coul...:

What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?

Resolution: The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.:

Can QEL and RX be added to an existing 9927?

Resolution: The QEL conversion kit (3' or 4') and the RX switch kit (050251-00) can convert the 9927 to QEL-RX9927 device.:

What power supply do I need for my 2 QELA devices with LCN auto operator?

Resolution: Use the PS902-2RS power supply with LCN auto operator on single door, PS904-2RS power supply on double door and PS904/906-2RS-2RS for 2 pair of QELA is required for basic operation with a...:

How many Von Duprin QEL devices can be connected to a power supply?

Resolution: Product Ordered before 7/10/2012 - Product identified by no label on QEL motor. You must use the 900-2Q option board with the PS900 power supplies to operate the QEL devices. The attached ta...:

Will the Von Duprin PS902 power supply operate the QEL device?

Resolution: The Von Duprin PS902 power supply will operate the QEL device as long as you also use the 900-2Q board for devices shipped prior to September of 2012. After July of 2012, the 900-2RS boa...:

Does the QEL retract the latch bolt and the pushpad?

Resolution: Yes the Von Duprin QEL exit device retracts the latch bolt and pushpad. Pushpad and latch bolt stay retracted as long as power is applied to the QEL exit device. :