Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Programming directions for CM lock ”

RELATED FAQS

Resolution: In order to manually program a CM lock, there must be a keypad on the reader. If there is not keypad on the reader, then the CM lock can't be manually programmed. Refer to the Schlage 1000 user pro...:

How do I manually program the AD300 RS-485 Address?

Resolution: Manually Setting the RS-485 Address This method is only available before the first network communication between an Access Control Panel (ACP) and the lock. Do a Level 1 and Level 2 Factory De...:

CM Magnetic Stripe Card Track Options

Resolution: CM locks with a magnetic stripe reader can only be set to read one of the three mag tracks at one time. The CM lock with magnetic stripe reader was shipped from the factory with the magnetic stripe...:

Where can I find AD/CO Series installation instructions?

Resolution: CO-Series Mortise Exit http://w3.securitytechnologies.com/irstdocs/installinstructions/102296 P516-269.pdf:

CM Lock

Resolution: Computer Managed, an Offline series of locks manufactured by Schlage Electronics.:

How do I program Locknetics CM / CL legacy locks with the Schlage Utility Software (SUS) and Hand Held Device (HHD)?

Resolution: - With the CIP NOT inserted and the Schlage Utility Software (SUS) running o Enter the Master Programming PIN or Present Loc...:

CM Lock Manual Programming Disabled

Resolution: When trying to program a CM lock, it may display an error code with a solid green light and 10 read flashes. This indicates the lock has already been programmed with computer software and manual ...: