Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ power draw on QEL ”

RELATED FAQS

Resolution: Applies only to Von Duprin QEL exit devices shipped after December 11th, 2014.1.0 amp inrush and a 0.14 amp holding current.:

Can I run 4 QEL devices from one PS902?

Resolution: No, you can only add one 900-2Q option board to the PS902 power supply and 900-2Q only can support two QEL devices.:

Does the QEL retract the latch bolt and the pushpad?

Resolution: Yes the Von Duprin QEL exit device retracts the latch bolt and pushpad. Pushpad and latch bolt stay retracted as long as power is applied to the QEL exit device. :

How many Von Duprin QEL devices can be connected to a power supply?

Resolution: Product Ordered before 7/10/2012 - Product identified by no label on QEL motor. You must use the 900-2Q option board with the PS900 power supplies to operate the QEL devices. The attached ta...:

Will the MPB-842 or MPB-840 power EL or QEL devices?

Resolution: The old MPB842 power supply will power up to two EL electric panic bars but will not power the QEL devices. A defective potted module inside the electric panic bar or defective power supply coul...:

What is the input / output of the 8200 series operator?

Resolution: The Falcon 8200 series operator requires a input of 120 VAC @ 1 Amp.:

Why is the battery draining so quickly on an AD-Series lock with a Keypad ONLY (KP) credential reader?

Resolution: A Technical Note has been generated to document one method of measuring battery current. See the attachment HERE.:

What is the power draw of a Senior Swing series operator?

Resolution: The Senior Swing (2800/9500) Series operator has a 120VAC @ 2.5 Amp current draw for a single door (2811/9531/9542) or simultaneous pair(2853/9553). The independent pair units (2863/...:

What current should an AD-Series or CO-Series lockset draw while in its low power "Sleep" mode?

Resolution: Use a multi-meter in series with the batteries to measure battery current. Be sure your multi-meter can accurately measure very low current, in the micro-amp range. See the attached Technical Not...: