Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Parts for ALK ”

RELATED FAQS

Question
Answer
What is the part number for the EAK PCB only for Monarch Falcon devices?
PCB only for the Alarm Kits prior to June 11th, 2012 is part #650335 and was used in the older 17 & 18 devices, 19, & pre June 2012 24/25's.
This circuit board will NOT work on the updated 24/25 Alarm Kits that released June 11th, 2012.
Can the Von Duprin Chexit device be changed to ALK exit alarm?
The Chexit device has a different base plate and center case than the ALK.  The Chexit device would need to be replaced with an ALK device.
What is the part number for the ALK sign?
The sign for exit alarm, ALK, is SIGN-1.
Can the green terminal block be soldered back on if it has broken off the ALK board?
If the green terminal block has been broken off of the exit alarm ALK you must replace the exit alarm ALK PC board part number 101030-00.
Why would the ALK chirp?
A low battery could cause the exit alarm ALK to chirp.  Replace the battery and if it is  still chirping, then replace the circuit board part number 101030-00.
The Von Duprin 98 or 99 ALK kit will not sound the horn
Followings are the reason for 98/99 exit alarm ALK not sound when push bar is activated. Make sure key switch on exit alarm ALK is turned on, wait for 20 seconds before you activating the pushba...
What is different about the updated Falcon Exit Alarm (EA) option ?
The Falcon Exit Alarm option was updated in June 2012 to include the following benefits. Louder Alarm 95dbs vs 87dbs Easier battery changes 24Vdc hardwire(HW) option included w...