Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ part number for QEL HD ”

RELATED FAQS

Question
Answer
What is the part number for a blank outside rose for the L locks?
The blank outside rose part number is 09-508.  This part is identical to the standard rose where a plug is installed inside the rose so a small seam is visible.  Mounting posts ...
What cleaning suggestions would you provide to a customer should the hand reader be exposed to blood?
To clean the platen on a hand reader, apply a Windex-like product with a clean, soft cloth and allow it to air dry.  The hand reader platen overlay has an anti-microbial surface.  Should ...
What is the part number for the EAK PCB only for Monarch Falcon devices?
PCB only for the Alarm Kits prior to June 11th, 2012 is part #650335 and was used in the older 17 & 18 devices, 19, & pre June 2012 24/25's.
This circuit board will NOT work on the updated 24/25 Alarm Kits that released June 11th, 2012.
Is the dogging assembly for the 17/18 device still available?
The 17, 18, & 19 devices use the same dogging assembly part #610480.
Replacement BNC Cable for SNAP Programmer
A replacement BNC cable has been found through the manufacturer, E-Z Hook.  This company makes electronic testing equipment, and this cable is believed to be a good working replacement fo...
This product is obsolete and is no longer available from Schlage Electronics.
What are the Von Duprin part numbers for RX, LX and RX,LX-LC switch kits for field installation?
The attached table shows the part numbers for LX-RX and LX-RX-LC switches field installed.
Do we offer HD-QEL?
We offer a couple different HD-QEL options:Hex key dogging (HD) is now available with Von Duprin non fire rated QEL33A/35A/98/99 electric exit devices that were shipped after De...