Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
outside door lock
”
RELATED FAQS
Question
Answer
How do I order a lock for a non-standard or thick door?
Resolution:
Most locks will have a standard door range they will install on, but occasionally customers will want to use them on thicker doors. In order to do so, the extended door thick...:
How to install an L9000 mortise lock less outside rose trim?
Resolution:
The L283-150 is a modified mounting plate to allow a user to only install trim on the inside of the L9000. For installation and door prep requirements, see the install sheet. Add...:
What are the steps to remove an S lock from the door?
Resolution:
Remove the inside rose then remove the two mounting screws and the inside and outside chassis will come off the door. See Installation Instructions here.:
Why does the Schlage button light up “Green” when I open the door?
Resolution:
When unlocking the CO200 door by mechanical key override, the green led will be continuously ON until the key is released. This will occur after firmware CO.A.6 (or later) has been installed int...:
How to remove a double cylinder deadbolt?
Resolution:
Schlage and Falcon double cylinder deadbolts have concealed screws to prevent tampering. The two methods used to conceal the thru-bolts are using screw caps or a faceplate. Use the below instructio...:
What parts do I need to convert my AL lock to fit a 2" thick door?
Resolution:
Part required by function:2 each A700-043 driver & A700-034** lever insert in addition to the chassis parts below:AL10S – 2 hubs A700-028AL25D – 2 hubs 1 A700-028 (inside), 1 A700-030 (outside)...:
How do you remove an AL lock from a door?
Resolution:
AL-Series and discontinued D Lever-Series locks use castle nuts to hold the chassis to the spring cages and to keep the chassis positioned in the door. This causes confusion at times when the lock ...:
How do you adjust for door thickness on an AL lock?
Resolution:
The standard door range for an AL lock is 1 3/8" to 1 7/8". Using the supplied instruction sheet, align the springcage post to desired door thickness by adjusting the outside castle nut. See inst...: