Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
NL-OP TRIM INSTALLATION INSTRUCTIONS
”
RELATED FAQS
Question
Answer
Does Von Duprin supply the 9875, 9975, 9875-F and 9975-F mortise exit devices with NL-OP trim function?
Resolution:
For night latch function with pull by others, the 98/99 series mortise exit device should be ordered as NL less trim, e.g., 9875NL-L/TRIM. We will furnish a device only, and the mortise cyl...:
How to order a 25-C device with the NL-OP trim function?
Resolution:
Device would be ordered as a 25C-C as of June 2012.The C-C suffix designates the 25C will come with the 718C-C cylinder control which uses a 1-¼" mortise with a narrow straight cam:
Is there a wood door template for the 9957?
Resolution:
There is not a wood template for 9957 three point latches, use the 98/99 rim template W10301 to get the correct device backset. For NL trim (990NL) use trim template and installation instruction W...:
Does the Von Duprin E996L trim require the NL drive screw be installed into the device to function properly?
Resolution:
Von Duprin 98/99 NL drive screw is located in back of the 98/99 center case assembly. NL drive screw should be left in with trim lock slide plate in up position in the 98/99 exit device with E99...:
Does Steelcraft have frame installation instructions?
Resolution:
It is always recommended to point installers to the industry installation manuals which are very comprehensive and are ANSI documentsClick here to get the updated link to the Steelcraft Shop M...:
Where is the template for the 718 trims made after 2/28/2011 for Falcon/Monarch concealed vertical rod devices?
Resolution:
Templates for current 718 series trim can also be found on Falcon website:
Can the 88 device be ordered as NL-OP?
Resolution:
You would have to order the device as 88NL less trim, the device will be shipped as an 88EO. The EO device has the proper backplate equipped with an NL cam to accept a rim cylinder ...: