ND series double dummy


Two ND170's can be mounted back to back as a double dummy set by using the threaded rod, N523-105.  This threaded rod must be ordered separately. 
To assemble, connect the threaded rod between both springcages (H) and spin springcages in opposite directions.   
The Falcon W12 single dummy lock cannot be mounted back-to-back to create a double dummy.  There is no access to surface mount the screws and the lever is held in place by a roll pin wh...
Schlage offers the AL170 single dummy trim, but for applications where a double dummy is needed you can install two AL170 dummy trims back-to-back.  Each AL170 is shipped with a threaded rod (part ...
All spindles are on a "square" at 0.312" (5/16")
The Schlage L-Series mortise lock spindle and spring part number can be found in the Table 1.     Spindles and Springs   Part Number  Description  L283-060 Spindle and spring, 1...
The 38-070 is a dummy mortise cylinder available in 1 1/8", 1 1/4", 1 3/8", 1 1/2" lengths.  The cylinder has an embossed faceplate to look like a standard cylinder but no keyway.
The 38-070 is not available in stainless finishes; 629 and 630.