Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ND Lock boring template ”

Resolution: The hole should be drilled in the field once the end cap is located on the door. It is a 5/8" hole, that is located 5/16" from the end of the mechanism case. See installation instruction of t...:

How can I tell if I have a new ND lock or the previous design?

Resolution: ND locks shipping on or after January 30, 2017 will look very similar when assembled to their predecessor that shipped prior to that date. There are several ways to distinguish the old versus the n...:

Why are there two different bore sizes on the templates for the B500 and B600 deadbolts?

Resolution: The bore size is dependent on the function of the deadbolt. Some functions can be installed into a 1 1/2" or 2 1/8" bore while others require 1 1/2" only. You need to reference the dead...:

Is there a tool to drill the thru bolt holes on cylindrical locks?

Resolution: Order the M204-198 thru-bolt jig, see Figure 1. Figure 1: M204-198 thru bolt jig The 40-080 was the old Schlage jig. The 030736-000-70 was the old Falcon jig. When the jig changed to...:

Which electric strike do I use for cylindrical locks used in a single door?

Resolution: The 6211 would be the most common electric strike to be used with cylindrical locks on a single door application. Check the template to confirm compatibility with specific cylindrical lock model n...:

What are the new announced ND-Series features?

Resolution: NOTE: ND locks manufactured on or after January 30, 2017 will no longer make use of the soft durometer spacer. The improved spring cage and matching lever eliminates the need for this spacer. ...:

How long is the ND tailpiece for a thick door?

Resolution: Schlage ND-Series tailpieces for extended doors are available by only two means, but are not available to order separately. If an extended tailpiece is needed, then a complete lock ...:

What replaced the old D series lever locks?

Resolution: The old D series lever lock was replaced by the ND lock in September 2003.:

What is the part number for a Schlage FSIC lever on an ND lock?

Resolution: On ND Series locks manufactuered prior to January 30, 2017:The ND FSIC lever part number was 03-032. :

Can an ND lock with SFIC cores be extended to fit a 3" extended outside door?

Resolution: ND locks can be extended up to 6" Extended Outside. :

What is the part number for a key in lever tailpiece for the ND lock?

Resolution: For modular designs: All functions except ND85 the tailpiece part number is N523-022. The ND85 tailpiece part number is N523-123. For non-modular designs: All functions except ND85 the t...:

When ordering the ND lock less cylinder will it come with a tailpiece?

Resolution: The Schlage ND is shipped with a driver/tailpiece when ordered with a LD, BD, or JD suffix.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ ND Lock boring template ”

RELATED FAQS